L293D Motor Driver Module
In Stock
- The driver two holes of 3 mm dia.
- Male burg-stick connectors for supply, ground and input connection.
- Screw terminal connectors for easy motor connection.
- High noise immunity inputs.
- Operating Voltage(VDC): 4.5 to 12
RS390 RS-390 390 6V-24V 4200-18900 RPM Carbon Brush DC Motor
In Stock
1.8V – 12V/2A DC Motor PWM Speed Regulator
In Stock
- Input supply voltage: 1.8V- 15V DC.
- The maximum output power: 30W
- Output current : 2A(Max).
- With resettable fuse.
- Equipped with LED indicator.
- Potentiometer with switch function for PWM adjustment.
PCA9685 16 Channel Servo Motor Drive
In Stock
- This is PCA9685 16 Channel Servo Motor Driver(Soldered)
- The operating voltage: 2.3V to 5.5V
- This has 5.5V tolerant inputs
- This can operate at minus 40 degrees Celsius to 85 degrees Celsius
- Software reset feature (SWRST Call) allows the device via I2C bus reset
- 25MHz internal oscillator requires no external components
- The maximum allowable 50MHz external clock input
BTS7960B 43A H-Bridge Motor Driver
In Stock
- This is BTS7960B 43A H-Bridge Motor Driver
- Double BTS7960 large current (43 A) H bridge driver
- The supply voltage: 5.5V to 27V
- This has Overtemperature shut down with latch behavior
- This has Overvoltage lockout and Undervoltage shut down
- The Driver circuit with logic level inputs.
- This has an onboard 5V power indicator
- This has a driver circuit with logic-level inputs.
Raspberry Pi USB Plug and Play Desktop Microphone
In Stock
- USB Microphone offers excellent sound quality with any plug-and-play enabled PC or Mac device
- Designed to filter out background noises for crisp, clear audio
- Neck is adjustable to fit wherever it's needed | USB Cable Length: 4 ft
- Plug : USB 2.0;Sensitivity : -67 dBV/pBar,-47 dBV/Pascal +/-4dB
- Flexible neck to adjust your convenient direction and Height for talking.
ZMPT101B AC Single Phase Voltage Sensor Transformer Module
In Stock
- Onboard precision miniature voltage transformer
- On-board high-precision op amp circuit, which performs functions such as accurate sampling and proper compensation of signals.
- The module can measure AC voltage within 250V, and the corresponding output analog can be adjusted.
- Sine wave, the middle value (DC component) of the waveform is 1/2VCC.
P45 Small Float Level Control Switch Plastic Float Switch
In Stock
- Contact Rating: 10 W.
- Switching Voltage: 220 V.
- Switching Current: 0.5 A.
- Breakdown Voltage: 220 VDC.
- Carry Current: 1 A.
- Contact Resistance: 100 mΩ.
GY-302 BH1750 Light Intensity Module
In Stock
- No ambient light distinction
- High precision determination accurate to 1 Lux for different lights
- ROHM original package BH1750FVI chip
- Operating Voltage: 3-5VDC
- Built-in 16bit A/D converter
- I2C interfac
16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi
In Stock
- Adjustable frequency PWM up to about 1.6 KHz
- 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
- Configurable push-pull or an open-drain output
- The output enable pin to quickly disable all the outputs
- Terminal block for power input
- Reverse polarity protection on the terminal block input
- Green power-good LED
Raspberry Pi Zero W (Wireless) With In-Built Wifi and Bluetooth
In Stock
- Operating Power: 5 V/2.5 A DC via micro USB
- 802.11 b/g/n wireless LAN
- Bluetooth 4.1
- Bluetooth Low Energy (BLE)
OE-775 Hall Effect Two Channel Magnetic Encoder
In Stock
801S Vibration Shock Sensor Module
In Stock
- Has a signal output instruction
- When the output valid signal is high, the light goes out
- The sensitivity is adjustable (fine-tuning)
- The wide detection range of vibration, no direction
- With mounting holes, firmware installation is flexible and convenient.
Raspberry Pi Compute Module 4 I/O Board
In Stock
- External power connector (+12V, +5V)
- 2 x full-size HDMI 2.0 connectors
- Gigabit Ethernet RJ45 with PoE support
- Micro USB socket for updating Compute Module 4
- PCIe Gen 2 x1 socket
JGB37-520 DC6V 960 RPM Miniature Speed Reduction Gear DC Motor
In Stock
- Motor model:JGB37-520
- Rated voltage:6V DC
- Revolving Speed: 960RPM
- Rated Torque: 0.07 kg. cm
- Stall Torque: 0.28 kg. cm
- Rated Current: 50 mA
- Stall Current: 1.5A

We specialize in providing DIY electronics kits and components, empowering makers and hobbyists to build innovative projects. We also develop final year projects for engineering students, delivering hands-on solutions for academic excellence.
Contact Us
Customer Service
Store Information
© 2025 AtomlabIndia. All rights reserved.















