We are currently making some changes on our site and products from our shop will be unavailable for next few days. Thank you for your patience and apologize for any inconvenience.
Filter

Showing 113–128 of 195 resultsSorted by popularity

Sort:
PC817 4 CH Optocoupler Isolation Module

PC817 4 CH Optocoupler Isolation Module

Original price was: ₹199.00.Current price is: ₹129.00.
Out of stock
SKU:008522
  1. I/O Isolation for MCUs (Micro Controller Units)
  2. Noise Suppression in Switching Circuits
  3. Driving Port Signal Voltage: 3.6-24V
  4. Output Port Voltage Port: 3.6-30V
  5. Output Can Be Switched From Pull-Up or Pull-Down With Jumpers.
Read more
NE555 Delay Monostable Switch Module Time Delay 12V

NE555 Delay Monostable Switch Module Time Delay 12V

Original price was: ₹99.00.Current price is: ₹57.00.
Out of stock
SKU:008516
  1. Module based on the NE555 chip.
  2. Input voltage: DC 12V
  3. Adjustable time: 0-10 s
  4. AC Control voltage: 250V/max. 10A
  5. Max. load: 2200W
Read more
1 channel 5V 10A Relay Control Board Module with Optocoupler

1 channel 5V 10A Relay Control Board Module with Optocoupler

Original price was: ₹79.00.Current price is: ₹52.00.
Out of stock
SKU:008505
  1. Channel: 1 channel
  2. Relay Voltage: 5V
  3. High impedance controller pin
  4. Pull-down circuit for the avoidance of malfunction
  5. One normally closed contact and one normally open contact
  6. Triode drive, increasing relay coil
Read more
4 Channel Isolated 5V 10A Relay Module opto coupler For Arduino PIC AVR DSP ARM

4 Channel Isolated 5V 10A Relay Module opto coupler For Arduino PIC AVR DSP ARM

Original price was: ₹199.00.Current price is: ₹134.00.
Out of stock
SKU:008500
  1. No. of Channel: 4
  2. Trigger Voltage: 5VDC
  3. Triode drive, increasing relay coil
  4. High impedance controller pin
  5. Pull-down circuit for the avoidance of malfunction
  6. Power supply indicator and Control indicator lamp
  7. Power supply and relay instructions, lit, the disconnect is off;
  8. The input signal, signal, common Terminal and start conducting;
Read more
6-30V 1-Channel Power Relay Module with Adjustable Timing

6-30V 1-Channel Power Relay Module with Adjustable Timing

Original price was: ₹149.00.Current price is: ₹107.00.
Out of stock
SKU:008496
  1. Operating voltage: 6-30V
  2. Time interval:0.1 s (minimum) ~ 999 min (maximum) continuously adjustable.
  3. Trigger Signal Source: High-Level Trigger (3.0 V-24 V)
  4. Output Capacity: can control no more than DC 30V 5A AC or 220 V devices 5A
  5. Optocoupler Isolation.
Read more
5-36v Switch Drive High-power MOSFET Trigger Module

5-36v Switch Drive High-power MOSFET Trigger Module

Original price was: ₹69.00.Current price is: ₹28.00.
Out of stock
SKU:008492
This 5-36v Switch Drive High-power MOSFET Trigger Module can control the output of power equipment, motors, light bulbs, LED lights, DC motors, micro-pumps,  solenoid valves, PWM, motor speed control, lamp brightness. etc.
Read more
D4184 Mosfet control Module Replacement Relay

D4184 Mosfet control Module Replacement Relay

Original price was: ₹69.00.Current price is: ₹37.00.
Out of stock
SKU:008486
  1. Model: D4184
  2. MOS tube: 40V 50A
  3. Dimensions: 23mm X 16mm
  4. Mounting Holes Diameter: 2mm
  5. Compatible with MCU and control board, 3V or 5V signal.
  6. High-level start, low-level stop, PWM speed regulation.
Read more
5V Dual Channel Relay Module with Optocoupler

5V Dual Channel Relay Module with Optocoupler

Original price was: ₹99.00.Current price is: ₹58.00.
Out of stock
SKU:008481
  1. Low Level Trigger Relay Module
  2. Two separate LEDs for On/Off indication of the Relay.
  3. Triggering input voltage 3.3V – 5V
  4. Two separate LEDs for On/Off indication of the Relay
  5. Triggering input voltage 3.3V – 5V 4)
  6. Back EMF protection
  7. Back EMF protection 2 LEDs to indicate when relays are ON.
  8. Works with logic level signals from 3.3V or 5V devices
  9. Opto isolation circuitry
  10. Module with diode current protection, short response time
  11. AC Control Voltage: 250V @max.10A
  12. DC Control Voltage: 30V @max. 10A
Read more
MX1919 Based Motor Driver Module – 2.5A

MX1919 Based Motor Driver Module – 2.5A

Original price was: ₹199.00.Current price is: ₹125.00.
In Stock
SKU:007737
  1. Operating Voltage: 2 – 10VDC
  2. Operating Current: 2.5A (max)
  3. Compatible With Arduino and Raspberry Pi
  4. 2 Pin Connectors for Motors and supply
Read more
TB6612 D1 Motor Driver Shield

TB6612 D1 Motor Driver Shield

Original price was: ₹749.00.Current price is: ₹683.00.
In Stock
SKU:007732
  1. Interface: I2C
  2. Power supply voltage: VM = 15V max
  3. Output current: Iout = 1.2A ( average ) / 3.2A ( peak )
  4. Standby control to save power CW / CCW / short brake / stop motor control modes
  5. Standby control mode-I2C mode: control TB6612’s STBY with I2C protocol
  6. IO mode: control TB6612’s STBY with Spin
Read more
Waveshare General Driver board for Robots, Based on ESP32

Waveshare General Driver board for Robots, Based on ESP32

Original price was: ₹2,999.00.Current price is: ₹2,745.00.
In Stock
SKU:007727
  1. Based on the ESP32-WROOM-32 module, supports wireless communication such as WIFI, Bluetooth and ESP-NOW
  2. Onboard motor control interfaces for 2x DC motor with encoder or 4x DC motor (2 groups) without encoder
  3. Onboard serial bus servos control interfaces for controlling up to 253 ST3215 serial bus servos and obtaining servos feedback
  4. Onboard 9-axis IMU to obtain attitude and heading information at any time
  5. Supports 7~13V power input, and can be powered directly by 2S or 3S lithium battery
Read more
Forward/Reverse Motor Controller Board 12V 24V Motor Two Relay Delay Timing Cycle YYB-5 Module

Forward/Reverse Motor Controller Board 12V 24V Motor Two Relay Delay Timing Cycle YYB-5 Module

Original price was: ₹999.00.Current price is: ₹923.00.
In Stock
SKU:007720
  1. Current Rating: 30 Amps
  2. Operation Mode: Automatic
  3. Coil Voltage: 24 Volts
  4. Model: YYB-5
  5. Input voltage: DC/ AC7V~27V
  6. Time range: 0.1 seconds to 999 minutes
Read more
DC7V-12V Brushless Motor Driver Controller Board For Hard Drive Motor 3/4 Wire

DC7V-12V Brushless Motor Driver Controller Board For Hard Drive Motor 3/4 Wire

Original price was: ₹599.00.Current price is: ₹527.00.
In Stock
SKU:007714
  1. Driver voltage: DC7-12V
  2. Working voltage: ≤1.2A
  3. Speed adjust:0%-100%
  4. Color: Green and Black
Read more
DC15V-36V-15A 500W Brushless Motor Controller Hall Motor Balanced Car Driver Board with Hall Drive

DC15V-36V-15A 500W Brushless Motor Controller Hall Motor Balanced Car Driver Board with Hall Drive

Original price was: ₹1,299.00.Current price is: ₹1,205.00.
In Stock
SKU:007708
  1. Voltage range: 15V-36V
  2. Peak current: 20A
  3. PWM speed control: PWM frequency 1-20KHZ
  4. Duty cycle: 0-100%
  5. Drive power: ≤ 500W
Read more
12V 24V 36V 40A PWM DC Motor Speed Controller Forward Reverse Adjustable Knob Switch Control Driver Digital Display

12V 24V 36V 40A PWM DC Motor Speed Controller Forward Reverse Adjustable Knob Switch Control Driver Digital Display

Original price was: ₹949.00.Current price is: ₹882.00.
In Stock
SKU:007701
  1. Input voltage: DC12 to 36V (equal to the rated voltage of the motor)
  2. Output voltage: linear under load
  3. Maximum current: 50A
  4. Continuous current: 40A
  5. Speed regulation mode: potentiometer (linear)
  6. Support motor: DC brush motor
Read more
Dual Monster Moto Shield VNH3ASP30 DC Motor Driver 2x14A (Peak 30A)

Dual Monster Moto Shield VNH3ASP30 DC Motor Driver 2x14A (Peak 30A)

Original price was: ₹3,999.00.Current price is: ₹3,114.00.
In Stock
SKU:007697
  1. Voltage Max: 16V
  2. Maximum current rating: 30 A
  3. Practical Continuous Current: 14 A
  4. Current sensing available to Arduino analog pin
  5. MOSFET on-resistance: 19 mΩ (per leg)
  6. Maximum PWM frequency: 20 kHz
  7. Thermal Shutdown
  8. Undervoltage and Overvoltage shutdown.
Read more

Filter Products

Categories

Filter by price

Product Status