“5V Single Channel RELAY Module” has been added to your cart. View cart
12 Volts DC Motor – 500 RPM
In Stock
- Operating Voltage(V): 12
- Rated Speed (RPM): 500
- Rated Torque(kg-cm): 0.7
- Stall Torque(kg-cm): 3
- No Load Current (A): 0.06
AC90-250V ESP8266, Wireless WIFI Relay, Module 1 Channel ESP-, 12F Wifi Development, Board AC/DC 5V/7-28V/5-, 80V Power Supply
In Stock
- Onboard Mature and stable ESP-12F WiFi module, high capacity 4M Byte Flash
- The I/O port of the WiFi module and the UART program download port are all extracted, convenient secondary development
- Onboard AC-DC switch power module, supply power way support AC90-250V/DC7-12V/USB5V
- Onboard Wifi module RST reset button
Purple Esp32 38pin Expansion Board
In Stock
ESP32 38PIN expansion board
In Stock
Ai Thinker ESP-01S ESP8266 WiFi Module
In Stock
- 1MB (8Mbit) Flash size.
- Very competitive price
- AP, STA, AP+STA modes available.
- Very simple AT commands, easy to use.
- Internal LWIP interface.
RC522 RFID 13.56MHZ Reader Writer Module
In Stock
- Voltage: DC 3.3V (Do not use 5V supply)
- Operating Current :13-26mA
- Idle Current :10-13mA
- Operating Frequency: 13.56MHz
- Highly integrated analog circuitry to demodulate and decode responses
- Supports ISO/IEC 14443 A/MIFARE
Seeed Studio XIAO ESP32C6
In Stock
- Processor: ESP32-C6 SoC with two 32-bit RISC-V processors (High-Performance and Low-Power).
- Memory: 512KB SRAM and 4MB Flash on-chip.
- 2.4GHz Wi-Fi 6 (802.11ax)
- Bluetooth 5.0 (LE)
- Zigbee
ESP8266 NodeMCU CP2102 WiFi Board Development Board
In Stock
- Open-source, Interactive, Programmable, Low cost, Simple, Smart, WI-FI enabled
- Arduino-like hardware IO
- Integrated TR switch, balun, LNA, power amplifier and matching network
- Integrated PLL, regulators, DCXO and power management units
- Onboard USB to serial chip to easily program and upload codes from the Arduino IDE
- Embeds logic level converter circuits
NEO-M8N GPS Module with Ceramic Active Antenna
In Stock
ESP WROOM 32 Wi-Fi Bluetooth Development Board -30 pin
In Stock
- Supply Voltage: 2.2 V ~ 3.6 V
- GPIO Pins: 38
- Current: 80 mA
- Data Rate: 54 Mbps.
- Flash Memory: 32Mbits
- Frequency: 2.4 GHz.
IRF520 MOSFET Driver Module for Arduino ARM Raspberry pi
In Stock
- Voltage: 3.3 – 5V.
- Ports: Digital Level.
- Output load voltage: 0-24 V.
- Output load current: <5A (1A above need to add heat sink).
- Platform: Arduino, MCU, ARM, raspberry pi.
5V Single Channel RELAY Module
In Stock
- ontrol Signal: Works with 5V TTL signals.
- Switching: Switches AC (up to 250V) and DC (up to 30V) loads.
- Relay Rating: Supports 5A at 240V AC.
- LED Indicator: Shows when the relay is ON.
- Wiring: 2×3-pin male header for easy connections.
MG90S Mini Servo Motor(180 Degree)
In Stock
- Model MG90S
- Weight 13 gm
- Operating voltage 4.8V~ 6.6V
- Servo Plug JR
- Stall torque @4.8V 1.8kg-cm
- Diameter: 5mm
- No. of Pins: 2
- Type of Mounting: PCB Through Hole
- Maximum Operating Temperature: +800°C (Approx.)
- Dark resistance:1-20 Mohm
170 Points Mini Breadboard SYB-170 White
In Stock
- Plug-n-play.
- Easy to use.
- Components are easily interconnected using 20-28 AWG wire
- 2.54 mm hole spacing
- ABS plastic material
170 pts Mini Breadboard SYB-170 Transparent
In Stock
- Tie-points: 170 (10×17)
- Size: 48 x 35 x 10 mm(LxWxH).
- Use: experimental, testing, robot
- Matching jumper, diameter 0.8mm
- Phosphor bronze nickel plated spring clips

We specialize in providing DIY electronics kits and components, empowering makers and hobbyists to build innovative projects. We also develop final year projects for engineering students, delivering hands-on solutions for academic excellence.
Contact Us
Customer Service
Store Information
© 2025 AtomlabIndia. All rights reserved.















