0
0 items
₹0.00
No products in the cart.
L293D Motor Driver Module
In Stock
- The driver two holes of 3 mm dia.
- Male burg-stick connectors for supply, ground and input connection.
- Screw terminal connectors for easy motor connection.
- High noise immunity inputs.
- Operating Voltage(VDC): 4.5 to 12
RS390 RS-390 390 6V-24V 4200-18900 RPM Carbon Brush DC Motor
In Stock
RS385 385 High Speed 12V – 24V 10000RPM – 20500RPM DC Motor
In Stock
- Speed: 10000 RPM
- Rated voltage: 12(V),
- Rated current: 0.15-0.75 (A).
- Rated speed: 10000 (rpm)
- Rated Torque: 70 (g. cm).
- Shaft Type: Round
- shaft Length: 13mm
- shaft Diameter: 2mm
- Motor Length: 56mm
- Motor Diameter: 27mm
1.8V – 12V/2A DC Motor PWM Speed Regulator
In Stock
- Input supply voltage: 1.8V- 15V DC.
- The maximum output power: 30W
- Output current : 2A(Max).
- With resettable fuse.
- Equipped with LED indicator.
- Potentiometer with switch function for PWM adjustment.
16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi
In Stock
- Adjustable frequency PWM up to about 1.6 KHz
- 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
- Configurable push-pull or an open-drain output
- The output enable pin to quickly disable all the outputs
- Terminal block for power input
- Reverse polarity protection on the terminal block input
- Green power-good LED
OE-775 Hall Effect Two Channel Magnetic Encoder
In Stock
801S Vibration Shock Sensor Module
In Stock
- Has a signal output instruction
- When the output valid signal is high, the light goes out
- The sensitivity is adjustable (fine-tuning)
- The wide detection range of vibration, no direction
- With mounting holes, firmware installation is flexible and convenient.
JGB37-520 DC6V 960 RPM Miniature Speed Reduction Gear DC Motor
In Stock
- Motor model:JGB37-520
- Rated voltage:6V DC
- Revolving Speed: 960RPM
- Rated Torque: 0.07 kg. cm
- Stall Torque: 0.28 kg. cm
- Rated Current: 50 mA
- Stall Current: 1.5A
KK board 2.1.5 Multi-Rotor LCD Flight Control Board
In Stock
- IC: Atmega644 PA
- Gyro/Acc: 6050MPU
- Input Voltage: 4.8V~6.0V
- AVR Interface: Standard 6 Pin
- Signal From Receiver: 1520us(5 channels)
- Signal to ESC: 1520 us
A2212 6T 2200KV Brushless Motor for Drone (Soldered Connector)
In Stock
- Model: A2212/6T
- Motor KV: 2200
- Max. Efficiency Current: 4-10A
- No Load Current: 0.5A @10V
- Current Capacity: 12A/60S
- LiPO Batteries: 2S-3S
720 Magnetic Micro Coreless Motor for Micro Quadcopters – 2xCW & 2xCCW
In Stock
- Model: 720
- Shaft Size: 1.0 mm
- Rated Voltage: 3.7 V.
- Current: 0.1 A.
- Rated RPM: 48000.
- Max Speed: 50000 RPM.
- Wire Length: 5cm
A2212 2450KV BLDC Motor for RC Drones and Quadcopters
In Stock
- Model: A2212/6T
- Motor KV: 2200
- Max. Efficiency Current: 4-10A
- No Load Current: 0.5A @10V
- Current Capacity: 12A/60S
- LiPO Batteries: 2S-3S
F450/F550 Quadcopter High Landing Gear
In Stock
- Color: black
- Material: ABS Plastic
- The span of the bottom: 330mm
- Height: 190mm
- Compatibility: F450 and F550 Frames
- Weight: 230
F450 / Q450 Quadcopter Frame – PCB Version Frame Kit
In Stock
- Wheelbase: 450mm
- Material: Glass Fiber + Polyamide-Nylon
- Motor Mounting Hole Diameter: 3 mm
- Arm Size: 220 x 40 (LxW) mm
- Arm mounting holes (on frame): 3 mm
- Arm mounting holes (on arm): 2 mm
Standard 30A BLDC ESC Electronic Speed Controller with Connector
In Stock
- Constant Current: 30A (Max 40A<10s).
- BEC: 5V 3A.
- Input Voltage: 11.1 ~ 11.7 V.
- Li-Po battery: 2S ~ 3S.
- Ni-MH 4-10 CELLS Auto Detect.

We specialize in providing DIY electronics kits and components, empowering makers and hobbyists to build innovative projects. We also develop final year projects for engineering students, delivering hands-on solutions for academic excellence.
Contact Us
Customer Service
Store Information
© 2025 AtomlabIndia. All rights reserved.















