0
0 items
₹0.00
No products in the cart.
12V 16 Channel Relay Module with Light Coupling LM2596 Power Supply
Out of stock
SKU:008594- 12V relay with AC contact capacity of 10A 250V and optocoupler protection.
- Onboard power supply module does not need an external power supply. I / O port driver is active low.
- The module can be used as microcontroller development board module and also as appliance control, PLC extended output.
- It is using the industry’s top -quality isolation optocouplers, strong anti-jamming ability, stable performance.
- The 1-16 road can be any full on/off or any road.
- All interfaces can be directly connected through the terminal leads, very convenient.
24V Dual Channel Relay Module (with Light Coupling)
Out of stock
SKU:008583- Operating Voltage: 24V DC
- Two separate LEDs for On/Off indication of the Relay
- Triggering input voltage 3.3V – 5V 4)
- Back EMF protection
- Equipped with high-current relay 10A@250VAC / 10A@30VDC
- It can control both AC and DC appliances such as Solenoids, Motors, lights, fans, etc
- High-quality screw terminals (Terminal Block) provided (C, NC, NO) for quick and easy connection
- Freewheeling diode to protect your microcontroller
- Input Signal Pin connected to Burg stick for easy accessibility
- Mounting holes provided
XH-M131 DC 12V Light Control Switch Photoresistor Relay Module
Out of stock
SKU:008573- Material – Steel, Plastic, PVC
- Power Supply – DC 12V
- Operating Current – Before the relay actuation: less than 5mA Relay after pull-in: 5V module is less than 50mA
- Switching Voltage: 250VAC@10A; 30VDC@10A
5V 1 Channel Without Light Coupling Relay
In Stock
SKU:008570- The 8550 transistor drive, driveability.
- A fixed bolt holes for easy installation.
- It has a relay status indicator led Power LED(Green), 8 relay status indicator LED(Red)
- Relay control interface by single-chip IO.
- Low-level suction close, high-level release.
- Easy to use, simple 3 line structure.
Timing Delay Switch Circuit with Double MOSFET Control
In Stock
SKU:008565- Wide voltage power supply (6~30V)
- supports micro USB 5.0V power supply
- The interface is clear and simple, powerful, easy to understand
- All set parameters automatically save power.
ESP8266 ESP-01 5V WiFi Relay Module
Out of stock
SKU:008560- Onboard Module: ESP8266 wifi module; in AP mode it can connect with 5 Clients at the same time
- Operating Way: cellphone carried on wifi module; cellphone and wifi module carried on the same router, and use the APP to control relay
- Transmission Distance : 400m (max)
- Relay : 5V,10A/250V AC 10A/30V DC
- Baud Rate: 9600.
- Diode effusion protection;
- Short response time
DC 12V Switch Delay-Relay Module with Adjustable Delay Time 0~25
Out of stock
SKU:008548- Module based on: NE555 chip.
- Precision Pulse Generation / Timing.
- Adjustable Duty Cycle.
- Monostable Operation.
- Standby no power consumption
- Countless Application and Information Sources.
- Time can be adjusted by a potentiometer, the default is 0-25 seconds.
- Module supplies a diode with an anti-power reverse connection.
5V 2 channel USB PC Intelligent Control Relay Module
Out of stock
SKU:008536- Contact type: NC / COM / NO
- Input current: ≥300mA
- Input voltage: DC 5V
- Support in all Windows OS.
- Onboard square USB interface, stable connection.
- Use imported high-performance USB control chip.
- Application code: Green indicates that the relay is closed, the red disconnect
- Military grade PCB board production.
8 Channel Isolated 5V 10A Relay Module opto coupler For Arduino PIC AVR DSP ARM
Out of stock
SKU:008531- Channel: 8 channel
- Relay Operating Voltage: 5V
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
1 Channel Relay Module, 30A with Optocoupler, Isolation 12V
Out of stock
SKU:008527- Channel: 1 channel
- Relay Voltage: 12V
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
PC817 4 CH Optocoupler Isolation Module
Out of stock
SKU:008522- I/O Isolation for MCUs (Micro Controller Units)
- Noise Suppression in Switching Circuits
- Driving Port Signal Voltage: 3.6-24V
- Output Port Voltage Port: 3.6-30V
- Output Can Be Switched From Pull-Up or Pull-Down With Jumpers.
NE555 Delay Monostable Switch Module Time Delay 12V
Out of stock
SKU:008516- Module based on the NE555 chip.
- Input voltage: DC 12V
- Adjustable time: 0-10 s
- AC Control voltage: 250V/max. 10A
- Max. load: 2200W
1 channel 5V 10A Relay Control Board Module with Optocoupler
Out of stock
SKU:008505- Channel: 1 channel
- Relay Voltage: 5V
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
4 Channel Isolated 5V 10A Relay Module opto coupler For Arduino PIC AVR DSP ARM
Out of stock
SKU:008500- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
6-30V 1-Channel Power Relay Module with Adjustable Timing
Out of stock
SKU:008496- Operating voltage: 6-30V
- Time interval:0.1 s (minimum) ~ 999 min (maximum) continuously adjustable.
- Trigger Signal Source: High-Level Trigger (3.0 V-24 V)
- Output Capacity: can control no more than DC 30V 5A AC or 220 V devices 5A
- Optocoupler Isolation.
5-36v Switch Drive High-power MOSFET Trigger Module
Out of stock
SKU:008492 This 5-36v Switch Drive High-power MOSFET Trigger Module can control the output of power equipment, motors, light bulbs, LED lights, DC motors, micro-pumps, solenoid valves, PWM, motor speed control, lamp brightness. etc.
Read more

We specialize in providing DIY electronics kits and components, empowering makers and hobbyists to build innovative projects. We also develop final year projects for engineering students, delivering hands-on solutions for academic excellence.
Contact Us
Customer Service
Store Information
© 2025 AtomlabIndia. All rights reserved.















