0
0 items
₹0.00
No products in the cart.
PC817 4 CH Optocoupler Isolation Module
Out of stock
SKU:008522- I/O Isolation for MCUs (Micro Controller Units)
- Noise Suppression in Switching Circuits
- Driving Port Signal Voltage: 3.6-24V
- Output Port Voltage Port: 3.6-30V
- Output Can Be Switched From Pull-Up or Pull-Down With Jumpers.
NE555 Delay Monostable Switch Module Time Delay 12V
Out of stock
SKU:008516- Module based on the NE555 chip.
- Input voltage: DC 12V
- Adjustable time: 0-10 s
- AC Control voltage: 250V/max. 10A
- Max. load: 2200W
1 channel 5V 10A Relay Control Board Module with Optocoupler
Out of stock
SKU:008505- Channel: 1 channel
- Relay Voltage: 5V
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
4 Channel Isolated 5V 10A Relay Module opto coupler For Arduino PIC AVR DSP ARM
Out of stock
SKU:008500- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
6-30V 1-Channel Power Relay Module with Adjustable Timing
Out of stock
SKU:008496- Operating voltage: 6-30V
- Time interval:0.1 s (minimum) ~ 999 min (maximum) continuously adjustable.
- Trigger Signal Source: High-Level Trigger (3.0 V-24 V)
- Output Capacity: can control no more than DC 30V 5A AC or 220 V devices 5A
- Optocoupler Isolation.
5-36v Switch Drive High-power MOSFET Trigger Module
Out of stock
SKU:008492 This 5-36v Switch Drive High-power MOSFET Trigger Module can control the output of power equipment, motors, light bulbs, LED lights, DC motors, micro-pumps, solenoid valves, PWM, motor speed control, lamp brightness. etc.
Read more
D4184 Mosfet control Module Replacement Relay
Out of stock
SKU:008486- Model: D4184
- MOS tube: 40V 50A
- Dimensions: 23mm X 16mm
- Mounting Holes Diameter: 2mm
- Compatible with MCU and control board, 3V or 5V signal.
- High-level start, low-level stop, PWM speed regulation.
5V Dual Channel Relay Module with Optocoupler
Out of stock
SKU:008481- Low Level Trigger Relay Module
- Two separate LEDs for On/Off indication of the Relay.
- Triggering input voltage 3.3V – 5V
- Two separate LEDs for On/Off indication of the Relay
- Triggering input voltage 3.3V – 5V 4)
- Back EMF protection
- Back EMF protection 2 LEDs to indicate when relays are ON.
- Works with logic level signals from 3.3V or 5V devices
- Opto isolation circuitry
- Module with diode current protection, short response time
- AC Control Voltage: 250V @max.10A
- DC Control Voltage: 30V @max. 10A
Waveshare WAVE ROVER Flexible And Expandable 4WD Mobile Robot Chassis, Full Metal Body
In Stock
SKU:007419- Chassis height: 33.70mm
- OLED screen: 0.91inch
- Tire width 42.50mm
- Running speed: 1.25m/s
- Tire diameter: 80mm
- Number of driving wheels: 4
Cligo Smart Robot Car Kit 2 WD for Kids
In Stock
SKU:007413Features:
- EasyMech’s branded Product.
- Easy to assemble, Snap-fit chassis
- Lightweight ABS Chassis.
- Hands-on experience of programming, electronics, and robotics
- Ages: 10+
EasyMech 100 mm HD Wheel Basic Shock Absorber Smart Car Robot Chassis
Out of stock
SKU:007406- EasyMech’s branded Product.
- Easy to assemble.
- Shock absorber chessis.
- Heavy-duty wheel Provides.
Cytron PikaBot – Maker UNO Smart Car Kit
In Stock
SKU:007400- Controller: Maker UNO
- No soldering needed, only requires to connect jumper wires
- Motor Driver: Maker Drive dual-channel DC brush motor driver
- Driven by two TT motor with pre-solder wires
- Power both controller and motor with 4 x AA battery, with battery holder too
- Comes with IR Line Sensor module, for line following
Intelligent Turtle Car Learning Suite Chassis
In Stock
SKU:007391DIY Nvidia JetsonNano Development Learning Kit (JetBot)
In Stock
SKU:007385- Powered by Jetson Nano Developer Kit V3, ideal for learning AI projects.
- Ready-to-assemble kit with no need for 3D printing or complex electronics setup.
- Interactive tutorials included for object tracking, collision avoidance, and more.
- Supports JetBot ROS & AWS RoboMaker, with AWS IoT Greengrass pre-installed.
M5STACK RoverC PRO (W/O M5StickC)
In Stock
SKU:007374- I2C Address 0x38
- LEGO compatible
- Equipped with 16340(700mAh) battery holder
- Control Chip: STM32F030C6T6
Cligo Wireless Remote Controlled Smart Car Chassis
In Stock
SKU:007370
We specialize in providing DIY electronics kits and components, empowering makers and hobbyists to build innovative projects. We also develop final year projects for engineering students, delivering hands-on solutions for academic excellence.
Contact Us
Customer Service
Store Information
© 2025 AtomlabIndia. All rights reserved.















