Filter
Sort:
DC 3-6 V Mini Micro Submersible Water Pump

DC 3-6 V Mini Micro Submersible Water Pump

₹45.00
In Stock
  1. Operating Voltage : 2.5 ~ 6V
  2. Operating Current : 130 ~ 220mA
  3. Flow Rate : 80 ~ 120 L/H
  4. Maximum Lift : 40 ~ 110 mm
  5. Outlet Outside Diameter: 7.5 mm
  6. Outlet Inside Diameter: 5 mm
Add to cart
DC Motor 9 Volts

DC Motor 9 Volts

₹15.00
In Stock
Add to cart
TowerPro SG90 Mini Servo – 360 degree Rotation – Standard Quality

TowerPro SG90 Mini Servo – 360 degree Rotation – Standard Quality

₹87.00
In Stock
  1. Model: SG90
  2. Weight: 9 gm
  3. Operating voltage: 3.0V~ 7.2V
  4. Servo Plug: JR
  5. Stall torque @4.8V : 1.2kg-cm
  6. Stall torque @6.6V : 1.6kg-cm
Add to cart
Original Arduino UNO EK R4 WiFi – Made in India

Original Arduino UNO EK R4 WiFi – Made in India

₹1,405.00
In Stock
  1. Made in India 32-bit Arduino board with WiFi and Bluetooth.
  2. Powered by Renesas R7FA4M1AB3CFM and ESP32-S3 module.
  3. 256 kB Flash, 32 kB SRAM, and 8 kB EEPROM.
  4. Built-in 12×8 programmable LED matrix for animations and games.
  5. Operating voltage: 5V, supports 6-24V input and USB-C.
  6. Advanced peripherals: DAC, CAN bus, 14-bit ADC.
Add to cart
Official Arduino UNO EK Minima (एक) R4 Made in India

Official Arduino UNO EK Minima (एक) R4 Made in India

₹868.00
In Stock
  1. Made in India 32-bit Arduino board.
  2. Renesas R7FA4M1AB3CFM, 48 MHz Cortex®-M4 processor.
  3. 256 kB Flash, 32 kB SRAM, 8 kB EEPROM.
  4. Compatible with older Arduino UNO shields.
  5. Advanced peripherals: ADC, DAC, RTC, CAN bus.
  6. Supports 6-24 V input and USB-C® power.
Add to cart
D1 Mini V2 NodeMcu 4M Bytes Lua WIFI Internet Of Things Development Board Based ESP8266

D1 Mini V2 NodeMcu 4M Bytes Lua WIFI Internet Of Things Development Board Based ESP8266

₹158.00
In Stock
  1. Use BRT (Bias Resistor Transistor)
  2. Easier into flash mode.
  3.  30% increase in radiating area
  4. Good stability.
Add to cart
Node MCU ESP8266 with CH340G USB-Serial Interface

Node MCU ESP8266 with CH340G USB-Serial Interface

₹240.00
In Stock
Add to cart
Node MCU ESP8266 with CP2102 USB-Serial Interface

Node MCU ESP8266 with CP2102 USB-Serial Interface

₹300.00
In Stock
  1. Open-source, Interactive, Programmable, Low cost, Simple, Smart, WI-FI enabled
  2. Arduino-like hardware IO
  3. Integrated TR switch, balun, LNA, power amplifier and matching network
  4. Integrated PLL, regulators, DCXO and power management units
  5. Onboard USB to serial chip to easily program and upload codes from the Arduino IDE
  6. Embeds logic level converter circuits
  7. Has onboard 3.3V regulator to ensure enough power to function as your go-to WiFi chip!
  8. Easy access to the GPIO pins for easy prototyping
  9. ESP-12E Processor
  10. Easy to use breadboard friendly form factor
Add to cart
Official Raspberry Pi Ai Camera- Built With Sony IMX500 Sensor

Official Raspberry Pi Ai Camera- Built With Sony IMX500 Sensor

₹7,899.00
In Stock
  1. Sensor: 12MP Sony IMX500 Intelligent Vision Sensor
  2. Integrated low-power inference engine
  3. Pre-loaded with MobileNet machine vision model
  4. 76-Degree field of view
  5. F1.79 Focal Ratio
  6. Manually adjustable focus
Add to cart
7Semi Mini ATmega328P Board – 5V

7Semi Mini ATmega328P Board – 5V

₹238.00
In Stock
  1. Microcontroller: ATmega328
  2. Circuit Operating Voltage: 5V
  3. Clock frequency: 16MHz.
  4. Digital I/O Pins: 14
  5. 8 analog input port: A0 ~ A7.
  6. A pair of TTL level serial port transceiver : RX / TX.
  7. 6 PWM port: D3, D5, D6, D9, D10, D11.
  8. Support serial download.
Add to cart
Mega +WiFi R3 Atmega2560+NodeMCU ESP8266 32Mb Memory USB-TTL CH340G Compatible For Arduino Mega

Mega +WiFi R3 Atmega2560+NodeMCU ESP8266 32Mb Memory USB-TTL CH340G Compatible For Arduino Mega

₹1,235.00
In Stock
Add to cart
Nano R3 W/O USB Cable Compatible with Arduino (Un Soldered)

Nano R3 W/O USB Cable Compatible with Arduino (Un Soldered)

₹188.00
In Stock
  1. Operating Voltage (logic level): 5V
  2. 8 analog inputs ports: A0 ~ A7
  3. 14 Digital input / output ports: TX, RX, D2 ~ D13
  4. 1 pair of TTL level serial transceiver ports RX / TX
  5. Using Atmel Atmega328P-AU MCU
  6. There is a bootloader installed in it
  7. Standard 0.1” spacing DIP (breadboard friendly).
  8. Manual reset switch.
Add to cart
UNO Based ESP8266 Nodemcu Development Board

UNO Based ESP8266 Nodemcu Development Board

₹230.00
In Stock
  1. Based on ESP-8266EX.
  2. Arduino compatible, using Arduino IDE to program.
  3. Support OTA wireless upload.
  4. Onboard 5V 1A Switching Power Supply (highest input voltage 24V).
  5. The direct use of Arduino IDE development, the same operation with Arduino UNO.
  6. Operating Voltage: 3.3V
  7. Digital I/O Pins: 11
  8. Analog Input Pins: 1
Add to cart
LilyPad 328 ATmega328P Main Board 16M Compatible with Arduino

LilyPad 328 ATmega328P Main Board 16M Compatible with Arduino

₹365.00
In Stock
  1. Microcontroller: ATmega168 or ATmega328V
  2. Operating Voltage: 2.7-5.5 V
  3. Digital I/O Pins: 14
  4. PWM Channels: 6
  5. Analog Input Channels: 6
  6. DC Current per I/O Pin: 40 mA
  7. Board will run from 2V to 5V.
  8. The latest version of the LilyPad supports automatic reset for even easier programming.
  9. The back side of the LilyPad is now completely flat!
Add to cart
Arduino MEGA R3 ATmega2560-16AU Development Compatible Board

Arduino MEGA R3 ATmega2560-16AU Development Compatible Board

₹1,335.00
In Stock
  1. Microcontroller: ATmega2560
  2. Operating Voltage: 5V
  3. Input Voltage (recommended): 7-12V
  4. Input Voltage (limits): 6-20V
  5. Digital I/O Pins: 54 (of which 15 provide PWM output)
  6. Analog Input Pins: 16
  7. DC Current per I/O Pin: 40 mA
  8. DC Current for 3.3V Pin: 50 mA
Add to cart
ATMEGA16U2 Arduino Mega 2560 R3 Improved Version CH340G Board

ATMEGA16U2 Arduino Mega 2560 R3 Improved Version CH340G Board

₹1,199.00
In Stock
  1. Microcontroller CH340
  2. Operating Voltage 5V
  3. Input Voltage (recommended) 7-12V
  4. Input Voltage (limits) 6-20V
  5. Digital I/O Pins 54 (of which 15 provide PWM output)
  6. Analog Input Pins 16
  7. DC Current per I/O Pin 40 mA
  8. Dimensions : 111 x 54 x 12 (LxWxH) mm.
Add to cart

Filter Products

Categories

Filter by price

Product Status