5
5 items
₹1,992.00
Subtotal: ₹1,992.00
Hurray! Your order qualifies for free shipping!
5
Subtotal: ₹1,992.00
Hurray! Your order qualifies for free shipping!
“Arduino UNO R3 Development Board ATMEGA16U2 ATMEGA328P (DIP)” has been added to your cart. View cart
- Operating Voltage: 5-15VDC
- No Load Current: 0.2A
- No-load Speed: 4000RPM
- Rated Torque: 265 g.cm
- Full Load Current: ≤2A
- Rated Current: ≤2A
DC 3-6 V Mini Micro Submersible Water Pump
In Stock
- Operating Voltage : 2.5 ~ 6V
- Operating Current : 130 ~ 220mA
- Flow Rate : 80 ~ 120 L/H
- Maximum Lift : 40 ~ 110 mm
- Outlet Outside Diameter: 7.5 mm
- Outlet Inside Diameter: 5 mm
TowerPro SG90 Mini Servo – 360 degree Rotation – Standard Quality
In Stock
- Model: SG90
- Weight: 9 gm
- Operating voltage: 3.0V~ 7.2V
- Servo Plug: JR
- Stall torque @4.8V : 1.2kg-cm
- Stall torque @6.6V : 1.6kg-cm
- Made in India 32-bit Arduino board with WiFi and Bluetooth.
- Powered by Renesas R7FA4M1AB3CFM and ESP32-S3 module.
- 256 kB Flash, 32 kB SRAM, and 8 kB EEPROM.
- Built-in 12×8 programmable LED matrix for animations and games.
- Operating voltage: 5V, supports 6-24V input and USB-C.
- Advanced peripherals: DAC, CAN bus, 14-bit ADC.
- Made in India 32-bit Arduino board.
- Renesas R7FA4M1AB3CFM, 48 MHz Cortex®-M4 processor.
- 256 kB Flash, 32 kB SRAM, 8 kB EEPROM.
- Compatible with older Arduino UNO shields.
- Advanced peripherals: ADC, DAC, RTC, CAN bus.
- Supports 6-24 V input and USB-C® power.
- Use BRT (Bias Resistor Transistor)
- Easier into flash mode.
- 30% increase in radiating area
- Good stability.
ESP8266 ESP-01 Remote Serial Port WIFI Transceiver Wireless Module
In Stock
- 802.11 b/g/n Standards
- Wi-Fi Direct (P2P), soft-AP
- 1MB Flash Memory
- Integrated low power 32-bit CPU could be used as an application processor
- A-MPDU & A-MSDU aggregation & 0.4ms guard interval
- Wake up and transmit packets in < 2ms
- Standby power consumption of < 1.0mW (DTIM3)
ESP32 CAM WiFi Bluetooth Module with OV2640 Camera Module
In Stock
- Open-source, Interactive, Programmable, Low cost, Simple, Smart, WI-FI enabled
- Arduino-like hardware IO
- Integrated TR switch, balun, LNA, power amplifier and matching network
- Integrated PLL, regulators, DCXO and power management units
- Onboard USB to serial chip to easily program and upload codes from the Arduino IDE
- Embeds logic level converter circuits
- Has onboard 3.3V regulator to ensure enough power to function as your go-to WiFi chip!
- Easy access to the GPIO pins for easy prototyping
- ESP-12E Processor
- Easy to use breadboard friendly form factor
Official Raspberry Pi Ai Camera- Built With Sony IMX500 Sensor
In Stock
- Sensor: 12MP Sony IMX500 Intelligent Vision Sensor
- Integrated low-power inference engine
- Pre-loaded with MobileNet machine vision model
- 76-Degree field of view
- F1.79 Focal Ratio
- Manually adjustable focus
7Semi Mini ATmega328P Board – 5V
In Stock
- Microcontroller: ATmega328
- Circuit Operating Voltage: 5V
- Clock frequency: 16MHz.
- Digital I/O Pins: 14
- 8 analog input port: A0 ~ A7.
- A pair of TTL level serial port transceiver : RX / TX.
- 6 PWM port: D3, D5, D6, D9, D10, D11.
- Support serial download.
Mega +WiFi R3 Atmega2560+NodeMCU ESP8266 32Mb Memory USB-TTL CH340G Compatible For Arduino Mega
In Stock
Nano R3 W/O USB Cable Compatible with Arduino (Un Soldered)
In Stock
- Operating Voltage (logic level): 5V
- 8 analog inputs ports: A0 ~ A7
- 14 Digital input / output ports: TX, RX, D2 ~ D13
- 1 pair of TTL level serial transceiver ports RX / TX
- Using Atmel Atmega328P-AU MCU
- There is a bootloader installed in it
- Standard 0.1” spacing DIP (breadboard friendly).
- Manual reset switch.
UNO Based ESP8266 Nodemcu Development Board
In Stock
- Based on ESP-8266EX.
- Arduino compatible, using Arduino IDE to program.
- Support OTA wireless upload.
- Onboard 5V 1A Switching Power Supply (highest input voltage 24V).
- The direct use of Arduino IDE development, the same operation with Arduino UNO.
- Operating Voltage: 3.3V
- Digital I/O Pins: 11
- Analog Input Pins: 1
LilyPad 328 ATmega328P Main Board 16M Compatible with Arduino
In Stock
- Microcontroller: ATmega168 or ATmega328V
- Operating Voltage: 2.7-5.5 V
- Digital I/O Pins: 14
- PWM Channels: 6
- Analog Input Channels: 6
- DC Current per I/O Pin: 40 mA
- Board will run from 2V to 5V.
- The latest version of the LilyPad supports automatic reset for even easier programming.
- The back side of the LilyPad is now completely flat!

We specialize in providing DIY electronics kits and components, empowering makers and hobbyists to build innovative projects. We also develop final year projects for engineering students, delivering hands-on solutions for academic excellence.
Contact Us
Customer Service
Store Information
© 2025 AtomlabIndia. All rights reserved.















