0
0 items
₹0.00
No products in the cart.
2 Channel Relay Module, 30A with Optocoupler, Isolation 12V Supports, High and Low Triger
Out of stock
SKU:008605- Supply Voltage: DC 12V
- Quiescent Current: 5mA
- Maximum Operating Current: 190mA
- Trigger Mode: High and low-level trigger
- Load Voltage: DC 30V / AC 250
- Load Current: 30A
- Relay Life: more than 100,000 times
12V 16 Channel Relay Module with Light Coupling LM2596 Power Supply
Out of stock
SKU:008594- 12V relay with AC contact capacity of 10A 250V and optocoupler protection.
- Onboard power supply module does not need an external power supply. I / O port driver is active low.
- The module can be used as microcontroller development board module and also as appliance control, PLC extended output.
- It is using the industry’s top -quality isolation optocouplers, strong anti-jamming ability, stable performance.
- The 1-16 road can be any full on/off or any road.
- All interfaces can be directly connected through the terminal leads, very convenient.
24V Dual Channel Relay Module (with Light Coupling)
Out of stock
SKU:008583- Operating Voltage: 24V DC
- Two separate LEDs for On/Off indication of the Relay
- Triggering input voltage 3.3V – 5V 4)
- Back EMF protection
- Equipped with high-current relay 10A@250VAC / 10A@30VDC
- It can control both AC and DC appliances such as Solenoids, Motors, lights, fans, etc
- High-quality screw terminals (Terminal Block) provided (C, NC, NO) for quick and easy connection
- Freewheeling diode to protect your microcontroller
- Input Signal Pin connected to Burg stick for easy accessibility
- Mounting holes provided
XH-M131 DC 12V Light Control Switch Photoresistor Relay Module
Out of stock
SKU:008573- Material – Steel, Plastic, PVC
- Power Supply – DC 12V
- Operating Current – Before the relay actuation: less than 5mA Relay after pull-in: 5V module is less than 50mA
- Switching Voltage: 250VAC@10A; 30VDC@10A
5V 1 Channel Without Light Coupling Relay
In Stock
SKU:008570- The 8550 transistor drive, driveability.
- A fixed bolt holes for easy installation.
- It has a relay status indicator led Power LED(Green), 8 relay status indicator LED(Red)
- Relay control interface by single-chip IO.
- Low-level suction close, high-level release.
- Easy to use, simple 3 line structure.
Timing Delay Switch Circuit with Double MOSFET Control
In Stock
SKU:008565- Wide voltage power supply (6~30V)
- supports micro USB 5.0V power supply
- The interface is clear and simple, powerful, easy to understand
- All set parameters automatically save power.
ESP8266 ESP-01 5V WiFi Relay Module
Out of stock
SKU:008560- Onboard Module: ESP8266 wifi module; in AP mode it can connect with 5 Clients at the same time
- Operating Way: cellphone carried on wifi module; cellphone and wifi module carried on the same router, and use the APP to control relay
- Transmission Distance : 400m (max)
- Relay : 5V,10A/250V AC 10A/30V DC
- Baud Rate: 9600.
- Diode effusion protection;
- Short response time
DC 12V Switch Delay-Relay Module with Adjustable Delay Time 0~25
Out of stock
SKU:008548- Module based on: NE555 chip.
- Precision Pulse Generation / Timing.
- Adjustable Duty Cycle.
- Monostable Operation.
- Standby no power consumption
- Countless Application and Information Sources.
- Time can be adjusted by a potentiometer, the default is 0-25 seconds.
- Module supplies a diode with an anti-power reverse connection.
5V 2 channel USB PC Intelligent Control Relay Module
Out of stock
SKU:008536- Contact type: NC / COM / NO
- Input current: ≥300mA
- Input voltage: DC 5V
- Support in all Windows OS.
- Onboard square USB interface, stable connection.
- Use imported high-performance USB control chip.
- Application code: Green indicates that the relay is closed, the red disconnect
- Military grade PCB board production.
8 Channel Isolated 5V 10A Relay Module opto coupler For Arduino PIC AVR DSP ARM
Out of stock
SKU:008531- Channel: 8 channel
- Relay Operating Voltage: 5V
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
1 Channel Relay Module, 30A with Optocoupler, Isolation 12V
Out of stock
SKU:008527- Channel: 1 channel
- Relay Voltage: 12V
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
PC817 4 CH Optocoupler Isolation Module
Out of stock
SKU:008522- I/O Isolation for MCUs (Micro Controller Units)
- Noise Suppression in Switching Circuits
- Driving Port Signal Voltage: 3.6-24V
- Output Port Voltage Port: 3.6-30V
- Output Can Be Switched From Pull-Up or Pull-Down With Jumpers.
NE555 Delay Monostable Switch Module Time Delay 12V
Out of stock
SKU:008516- Module based on the NE555 chip.
- Input voltage: DC 12V
- Adjustable time: 0-10 s
- AC Control voltage: 250V/max. 10A
- Max. load: 2200W
1 channel 5V 10A Relay Control Board Module with Optocoupler
Out of stock
SKU:008505- Channel: 1 channel
- Relay Voltage: 5V
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
4 Channel Isolated 5V 10A Relay Module opto coupler For Arduino PIC AVR DSP ARM
Out of stock
SKU:008500- No. of Channel: 4
- Trigger Voltage: 5VDC
- Triode drive, increasing relay coil
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- Power supply indicator and Control indicator lamp
- Power supply and relay instructions, lit, the disconnect is off;
- The input signal, signal, common Terminal and start conducting;
6-30V 1-Channel Power Relay Module with Adjustable Timing
Out of stock
SKU:008496- Operating voltage: 6-30V
- Time interval:0.1 s (minimum) ~ 999 min (maximum) continuously adjustable.
- Trigger Signal Source: High-Level Trigger (3.0 V-24 V)
- Output Capacity: can control no more than DC 30V 5A AC or 220 V devices 5A
- Optocoupler Isolation.

We specialize in providing DIY electronics kits and components, empowering makers and hobbyists to build innovative projects. We also develop final year projects for engineering students, delivering hands-on solutions for academic excellence.
Contact Us
Customer Service
Store Information
© 2025 AtomlabIndia. All rights reserved.















