0
0 items
₹0.00
No products in the cart.
We are currently making some changes on our site and products from our shop will be unavailable for next few days. Thank you for your patience and apologize for any inconvenience.
5V 8 Channel SSR Module
Out of stock
SKU:006757- 8-channel 2 AMP Solid State Relay board.
- Control 8 loads of up to 2 amps each at 120 V or 240 V AC.
- Good for lighting, Holiday displays etc.
- Has been assembled, and the electrical test passed.
- Led indicator for each relay.
- Use it to control various appliances and other equipment with large current.
- It can be controlled directly by a Microcontroller.
5V 1 Channel SSR Module
Out of stock
SKU:006752- 1-Channel Solid-State Relay
- Rated output load: 100V ~ 240V AC (50Hz/ 60Hz) 2A per channel
- Rated input voltage: 5V
- Triggered at Low level
- Separate LEDs showing the status of each Solid-State Relay
5V 2 Channel SSR Module
Out of stock
SKU:006747- 2-Channel Solid-State Relay
- Rated output load: 100V ~ 240V AC (50Hz/ 60Hz) 2A per channel
- Rated input voltage: 5V
- Triggered at Low level
- Separate LEDs showing the status of each Solid-State Relay
LM386 Audio Amplifier Module
Out of stock
SKU:006741- Onboard LM386 Chip.
- 200 multiplier benefits circuit design.
- On-board speaker wiring Block.
- On-board 10K variable resistor, you can adjust the volume of the enlarged.
- Onboard power indicator.
1200w DC DC Boost Step Up Converter 8-60V to 12-83V 20A
Out of stock
SKU:006731- Input voltage :10-60V
- Output voltage: 12-83V (adjustable)
- Output Current: 12A
- Input Current: 20A
- The non-isolated step-up power conversion module
- Onboard LED illuminates when the voltage is applied to the module
- Equips Multi-turn Potentiometer.
PCA9685 16 Channel Servo Motor Drive
In Stock
SKU:006721- This is PCA9685 16 Channel Servo Motor Driver(Soldered)
- The operating voltage: 2.3V to 5.5V
- This has 5.5V tolerant inputs
- This can operate at minus 40 degrees Celsius to 85 degrees Celsius
- Software reset feature (SWRST Call) allows the device via I2C bus reset
- 25MHz internal oscillator requires no external components
- The maximum allowable 50MHz external clock input
LM317 DC Linear Regulator, DC-DC 4.5~40V Turn 1.2~37V, Step Down Power Module, Adjustable
Out of stock
SKU:006712- Output Current: 1.5A (minimum), 2.2A (typ)
- Input and output voltage difference (VI-VO): 40Vdc (max)
- Adjustable output voltage range: 1.2 ~ 37V
- Operating temperature: -55 to +150
- Output Current: 1.5A
- Input voltage: 4.2 ~ 40 V
Raspberry Pi USB Plug and Play Desktop Microphone
In Stock
SKU:006708- USB Microphone offers excellent sound quality with any plug-and-play enabled PC or Mac device
- Designed to filter out background noises for crisp, clear audio
- Neck is adjustable to fit wherever it's needed | USB Cable Length: 4 ft
- Plug : USB 2.0;Sensitivity : -67 dBV/pBar,-47 dBV/Pascal +/-4dB
- Flexible neck to adjust your convenient direction and Height for talking.
24V/12V to 5V 5A Power Module DC-DC XY-3606 Power Converter
In Stock
SKU:006699- Working voltage: DC 9V–36V
- Output voltage: 5.2V/5A/25W
- 9~24V input: Output 5.2V/6A/30W
- 24~32V input: output 5.2V/5A/25W
- 32~36V input: output 5.2V/3.5A/18W
SD Card Module
Out of stock
SKU:006673- The level conversion circuit board that can interface level is 5V or 3.3V support micro SD card, micro SDHC card (high-speed card)
- Power supply is 4.5V ~ 5.5V, 3.3V voltage regulator circuit board Communication interface is a standard SPI interface 4 M2 screw positioning holes for easy installation.
- Control Interface: A total of six pins (GND, VCC, MISO, MOSI, SCK, CS), GND to ground, VCC is the power supply, MISO, MOSI, SCK is the SPI bus, CS is the chip select signal pin Level
- Conversion Circuit: Micro SD card into the direction of signals into 3.3V, microSD card toward the direction of the control interface
- MISO signal is also converted to 3.3V, general AVR microcontroller system can read the signal Control Interface: A total of six pins (GND, VCC, MISO, MOSI, SCK, CS), GND to ground, VCC is the power supply, MISO, MOSI, SCK is SPI bus, CS is the chip select signal pin
P45 Small Float Level Control Switch Plastic Float Switch
In Stock
SKU:006668- Contact Rating: 10 W.
- Switching Voltage: 220 V.
- Switching Current: 0.5 A.
- Breakdown Voltage: 220 VDC.
- Carry Current: 1 A.
- Contact Resistance: 100 mΩ.
NEO-6M GPS Module with EPROM
In Stock
SKU:006664- 5Hz position update rate.
- The cold start time of 38 s and Hot start time of 1 s.
- Configurable from 4800 Baud to 115200 Baud rates. (default 9600).
- Super Sense Indoor GPS: -162 dBm tracking sensitivity.
- Support SBAS (WAAS, EGNOS, MSAS, GAGAN).
- Separated 18 x 18mm GPS antenna.
5V 16 Channel Relay Module
Out of stock
SKU:006656- Versatile Control: This 16 Channel 5V Relay Module lets you control up to 16 devices simultaneously.
- Optocoupler Protection: Equipped with optocoupler protection, it ensures reliable and interference-free operation.
- Universal Compatibility: Compatible with Arduino, 8051, AVR, PIC, DSP, ARM, MSP430, TTL logic, and more.
- Industrial Quality: Integrated with industrial-grade optocouplers for robust performance and anti-jamming ability.
- Easy to Use: Standard interface and indication LEDs for relay output status make it user-friendly.
- Multiple Applications: Ideal for microcontroller development, home appliance control, and PLC extended output.
- Reliable Performance: Made with quality components, this module provides efficient and dependable performance.
2 CH 12V Relay Board
In Stock
SKU:006646- The board is a 2 channel relay which works on 12V.
- The input signal can come directly from a microcontroller.
- Each relay can switch the variety of AC or DC high voltage.
- Current loads working at 110V or 220V AC mains like lights, fans, motors and such
GY-302 BH1750 Light Intensity Module
In Stock
SKU:006641- No ambient light distinction
- High precision determination accurate to 1 Lux for different lights
- ROHM original package BH1750FVI chip
- Operating Voltage: 3-5VDC
- Built-in 16bit A/D converter
- I2C interfac
Solenoid valve switch 12V DC 1/2 inch (Normally Closed)
Out of stock
SKU:006634- This is the Solenoid valve 12V
- This is suitable for fluids like water, oil, air.
- This prevents the dry burning and provide a steady flow
- This is Precise and reliable.
- This valve is Compact and convenient.
- This is easily installed and serviced

We specialize in providing DIY electronics kits and components, empowering makers and hobbyists to build innovative projects. We also develop final year projects for engineering students, delivering hands-on solutions for academic excellence.
Contact Us
Customer Service
Store Information
© 2025 AtomlabIndia. All rights reserved.















