0
0 items
₹0.00
No products in the cart.
L293D Motor Driver Module
In Stock
- The driver two holes of 3 mm dia.
- Male burg-stick connectors for supply, ground and input connection.
- Screw terminal connectors for easy motor connection.
- High noise immunity inputs.
- Operating Voltage(VDC): 4.5 to 12
RS390 RS-390 390 6V-24V 4200-18900 RPM Carbon Brush DC Motor
In Stock
MB102 830 Points Solderless Prototype PCB Breadboard High Quality
In Stock
- SKU : AE1001
- Mb102 Bread Board
- 830 Solder-less Points
- Ideal for Experimenting With Circuit Design In Labs
- Compatible with resistance, diodes, transistors, LED’s, Capacitors and other types of electronic components
- Colored coordinates for easy components placement.
1.8V – 12V/2A DC Motor PWM Speed Regulator
In Stock
- Input supply voltage: 1.8V- 15V DC.
- The maximum output power: 30W
- Output current : 2A(Max).
- With resettable fuse.
- Equipped with LED indicator.
- Potentiometer with switch function for PWM adjustment.
PCA9685 16 Channel Servo Motor Drive
In Stock
- This is PCA9685 16 Channel Servo Motor Driver(Soldered)
- The operating voltage: 2.3V to 5.5V
- This has 5.5V tolerant inputs
- This can operate at minus 40 degrees Celsius to 85 degrees Celsius
- Software reset feature (SWRST Call) allows the device via I2C bus reset
- 25MHz internal oscillator requires no external components
- The maximum allowable 50MHz external clock input
BTS7960B 43A H-Bridge Motor Driver
In Stock
- This is BTS7960B 43A H-Bridge Motor Driver
- Double BTS7960 large current (43 A) H bridge driver
- The supply voltage: 5.5V to 27V
- This has Overtemperature shut down with latch behavior
- This has Overvoltage lockout and Undervoltage shut down
- The Driver circuit with logic level inputs.
- This has an onboard 5V power indicator
- This has a driver circuit with logic-level inputs.
ZMPT101B AC Single Phase Voltage Sensor Transformer Module
In Stock
- Onboard precision miniature voltage transformer
- On-board high-precision op amp circuit, which performs functions such as accurate sampling and proper compensation of signals.
- The module can measure AC voltage within 250V, and the corresponding output analog can be adjusted.
- Sine wave, the middle value (DC component) of the waveform is 1/2VCC.
P45 Small Float Level Control Switch Plastic Float Switch
In Stock
- Contact Rating: 10 W.
- Switching Voltage: 220 V.
- Switching Current: 0.5 A.
- Breakdown Voltage: 220 VDC.
- Carry Current: 1 A.
- Contact Resistance: 100 mΩ.
GY-302 BH1750 Light Intensity Module
In Stock
- No ambient light distinction
- High precision determination accurate to 1 Lux for different lights
- ROHM original package BH1750FVI chip
- Operating Voltage: 3-5VDC
- Built-in 16bit A/D converter
- I2C interfac
Solenoid valve switch 12V DC 1/2 inch (Normally Closed)
In Stock
- This is the Solenoid valve 12V
- This is suitable for fluids like water, oil, air.
- This prevents the dry burning and provide a steady flow
- This is Precise and reliable.
- This valve is Compact and convenient.
- This is easily installed and serviced
16-Channel 12-bit PWM/Servo Driver I2C interface PCA9685 for Arduino Raspberry Pi
In Stock
- Adjustable frequency PWM up to about 1.6 KHz
- 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate
- Configurable push-pull or an open-drain output
- The output enable pin to quickly disable all the outputs
- Terminal block for power input
- Reverse polarity protection on the terminal block input
- Green power-good LED
Soldron High Quality 75W/230V Soldering Iron
In Stock
- Brand: Soldron
- Output: 75 Watts
- Operating voltage: 110 to 230V AC
- Colour: Black-Green
- Bit tip Diameter: 7mm
Soldron High-Quality 230V/50W Soldering Iron
In Stock
- Attains full operating Temperature within a seconds.
- Maintains constant tip temperature.
- Low Leakage Current.
- Safe for the use on dedicated and sensitive Components.
- Maximum Heat transfer efficiency.
- Slide on a Replaceable tip.
- Cool Grip Insulating Nylon Handle
OE-775 Hall Effect Two Channel Magnetic Encoder
In Stock
801S Vibration Shock Sensor Module
In Stock
- Has a signal output instruction
- When the output valid signal is high, the light goes out
- The sensitivity is adjustable (fine-tuning)
- The wide detection range of vibration, no direction
- With mounting holes, firmware installation is flexible and convenient.

We specialize in providing DIY electronics kits and components, empowering makers and hobbyists to build innovative projects. We also develop final year projects for engineering students, delivering hands-on solutions for academic excellence.
Contact Us
Customer Service
Store Information
© 2025 AtomlabIndia. All rights reserved.















