“Ai Thinker ESP-01S ESP8266 WiFi Module” has been added to your cart. View cart
- Operating Voltage: 5 V
- Sonar Sensing Range: 2-400 cm
- Max. Sensing Range: 4500 cm
- Frequency: 40 KHz
- Thickness: 2.8-3.1 mm
- The diameter of mounting hole: 3.8mm
- Mounting Bracket Material: acrylic
- Voltage: 3.3 – 5V.
- Ports: Digital Level.
- Output load voltage: 0-24 V.
- Output load current: <5A (1A above need to add heat sink).
- Platform: Arduino, MCU, ARM, raspberry pi.
- ontrol Signal: Works with 5V TTL signals.
- Switching: Switches AC (up to 250V) and DC (up to 30V) loads.
- Relay Rating: Supports 5A at 240V AC.
- LED Indicator: Shows when the relay is ON.
- Wiring: 2×3-pin male header for easy connections.
- Low-noise analog signal path.
- Device bandwidth is set via the new FILTER pin.
- 5 µs output rise time in response to step input current.
- Small footprint, low-profile SOIC8 package.
- 2.1 kV RMS minimum isolation voltage from pins 1-4 to pins 5-8.
- Low-noise analog signal path
- Device bandwidth is set via the new FILTER pin
- 5 µs output rise time in response to step input current
- Small footprint, low-profile SOIC8 package
- 2.1 kVRMS minimum isolation voltage from pins 1-4 to pins 5-8
- Model: MQ-6
- Operating Voltage: 5V DC
- Detecting Range:200-10000 ppm
- Relative Humidity:<95% RH
- 5V power supply.
- Serial I2C control of LCD display using PCF8574.
- Backlight can be enabled or disabled via a jumper on the board.
- Contrast control via a potentiometer.
- Can have 8 modules on a single I2C bus (change address via solder jumpers)address, allowing.
- Model : KY-040.
- Type : Incremental Encoder.
- Cycles per revolution (CPR) : 20.
- Working voltage : 0 – 5V.
- Material : PCB + Brass.
- Mounting Nut Thread diameter: 6.6mm
- 1 Hz output pin SQW.
- 32 KHz output pin 32K.
- Voltage Supply: 2.2 V ~ 5.5 V (for RTC).
- Time Format: HH: MM: SS (12/24 hr).
- Date Format: YY-MM-DD-dd.
- Operating Voltage: 3V-5V
- High-resolution conversion of light intensity to frequency.
- Chip pins all has drawn for standard 100.
- Put the needle (2.54 mm).
- Mil-convenient for bitmap board.
- Programmable color and full-scale output frequency.
- Using SW-420 normally closed type vibration sensor
- Comparator output, clean signal, good waveform, strong driving ability, >15mA
- Operating voltage 3.3V ~ 5V
- Output format: digital switching output (0 and 1)
- Using a wide voltage LM393 comparator
- Main chip: LM393, Electret condenser microphone
- Working voltage: DC 3.3-5V
- Induction distance is 0.5M
- Signal output Indication
- Single channel signal output

We specialize in providing DIY electronics kits and components, empowering makers and hobbyists to build innovative projects. We also develop final year projects for engineering students, delivering hands-on solutions for academic excellence.
Contact Us
Customer Service
Store Information
© 2025 AtomlabIndia. All rights reserved.