Brushless Motor Controller DC 12-36V 500W PWM Driver Board
Brushless Motor Controller DC 12-36V 500W PWM Driver Board - Image 2

Brushless Motor Controller DC 12-36V 500W PWM Driver Board

₹1,078.00

In Stock
Category:

Description

The Brushless Motor Controller DC 12-36V 500W PWM Driver Board is designed specifically for quadcopters and multi-rotors, offering enhanced motor speed control for superior flight performance compared to standard ESCs.

This driver board is compatible with 3-phase brushless sensorless motors but may not work optimally with all sensorless motors right out of the box. If issues arise—such as motor startup jitter, reverse operation, high no-load current, unstable speeds, or poor efficiency—users can fine-tune the board by adjusting the resistance and capacitance. These adjustments will help optimize performance and ensure smooth operation under varying conditions.

Specifications and Features :

Protection: Overload protection, locked-rotor protection, over-current protection

Analog voltage speed regulation: 0-5V

Operating temperature: -40 ~ +85℃

Drive power: ≤ 500W (related working voltage)

Speed control function: voltage speed regulation or single-chip

microcomputer control PWM speed regulation

Wiring Diagram:

 

wiring diagram

 

Pin Connection :
5V -Driver board internal output voltage
Signal – Motor speed pulse signal output port, 5V pulse signal.

Control port: 

Z/F– Rotating direction control ports. Connect “5V” high level or no connect is Forward direction, connect 0 V low level or connect to GND is a reverse direction.
VR -Speed control port. Analog voltage linear speed regulation 0.1v -5V, The input resistance is 20K Ohm, connect with GND when input PWM speed regulation, PWM frequency:1-20KHZ; Duty cycle 0-100%
GND—Used for Drive board internal control.

Power port : 

MA —-motor phase A
MB —- motor phase B
MC—- motor phase C
GND—-DC-
VCC—-DC +
3. Use shielded wires if the drivers’ board has more than 50 cm distance from the motor, otherwise, it may lead to abnormal driving, affecting the normal use.
4.Control port distance: 2.54mm,Power port distance: 3.96 mm
5. Pay attention to the insulation between the driver MOSFET and the heatsink or the installation plate.
Application notes:

Confirm that the voltage and power parameters of the motor do not exceed the range of the driver board as specified.

The JYQD-V6.3E1 driver board is a bare board without housing and a heatsink. If the power of the motor is below 60W, it does not need to add a heatsink, It only needs to ensure normal ventilation and wall insulation. If the power of the motor is more than 100W, it must add a heatsink.

Please take note that the JYQD-V6.3E1  driver board has no anti-reverse connection protection, it will permanently damage the driver board if reversed polarity connection.

The 5V output port on the driver board prohibits connecting an external device. It is only applicable to the external potentiometer and switch of the board for speed regulation and reversal.

The “Signal” terminal on the JYQD-V6.3E1 driver board is the motor speed pulse output signal (push-pull output), and the maximum output current is less than 5mA.

Package Includes :

1 x DC 12V-36V 500W Brushless Motor Controller Driver Board