0
0 items
₹0.00
No products in the cart.
5V 4 Channel SSR Solid State Relay Module 240V 2A Output with Resistive Fuse
In Stock
SKU:008619- Has been assembled, and electrical test passed.
- Led indicator for each relay.
- Operating Voltage: 5V
- Operating Current: 12.5mA
- Maximum Load: 2A @ 240VAC
2 Channel Relay Module 30A with Optocoupler Isolation 5V Supports High and Low Triger
In Stock
SKU:008615- Supply Voltage: DC 5V
- Quiescent Current: 5mA
- Maximum Operating Current: 190mA
- Trigger Mode: High and low-level trigger
- Load Voltage: DC 30V / AC250
- Load Current: 30A
- Relay Life: more than 100,000 times
1 Channel Relay Module, 30A with Optocoupler, Isolation 5V Supports, High and Low Triger
In Stock
SKU:008609- Channel: 1 channel
- Relay Voltage: 5V
- High impedance controller pin
- Pull-down circuit for the avoidance of malfunction
- One normally closed contact and one normally open contact
- Triode drive, increasing relay coil
2 Channel Relay Module, 30A with Optocoupler, Isolation 12V Supports, High and Low Triger
In Stock
SKU:008605- Supply Voltage: DC 12V
- Quiescent Current: 5mA
- Maximum Operating Current: 190mA
- Trigger Mode: High and low-level trigger
- Load Voltage: DC 30V / AC 250
- Load Current: 30A
- Relay Life: more than 100,000 times
1 Channel 5V Relay Module Solid State High Level SSR DC Control 250V 2A with Resistive Fuse
In Stock
SKU:008600- Part Number: G3MB-202P
- Power supply:5VDC/160mA
- Switching Voltage (VAC):240@2A
- Isolation: Phototriac
12V 16 Channel Relay Module with Light Coupling LM2596 Power Supply
In Stock
SKU:008594- 12V relay with AC contact capacity of 10A 250V and optocoupler protection.
- Onboard power supply module does not need an external power supply. I / O port driver is active low.
- The module can be used as microcontroller development board module and also as appliance control, PLC extended output.
- It is using the industry’s top -quality isolation optocouplers, strong anti-jamming ability, stable performance.
- The 1-16 road can be any full on/off or any road.
- All interfaces can be directly connected through the terminal leads, very convenient.
5V 2 Channel SSR G3MB-202P Solid State Relay Module 240V 2A Output with Resistive Fuse
In Stock
SKU:008589- 2 channel 2 AMP Solid State Relay board
- Control 2 loads of up to 2 amps each at 120V or 240V AC.
- Good for lighting, holiday displays etc.
- Input control signal voltage:
- 0-0.5V the state of low-level relay ON
- 0.5-3.3V Unknown State
- 3.3-5V high-level relay OFF
- Operating Voltage: 5V
- Operating Current: 16mA
- Maximum Load: 2A @ 240VAC
24V Dual Channel Relay Module (with Light Coupling)
In Stock
SKU:008583- Operating Voltage: 24V DC
- Two separate LEDs for On/Off indication of the Relay
- Triggering input voltage 3.3V – 5V 4)
- Back EMF protection
- Equipped with high-current relay 10A@250VAC / 10A@30VDC
- It can control both AC and DC appliances such as Solenoids, Motors, lights, fans, etc
- High-quality screw terminals (Terminal Block) provided (C, NC, NO) for quick and easy connection
- Freewheeling diode to protect your microcontroller
- Input Signal Pin connected to Burg stick for easy accessibility
- Mounting holes provided
A03B 1 Road 5v Low Level Solid State Relay Module with Fuse SSR 250V 2A Fuse
In Stock
SKU:008578- Trigger voltage: 5VDC
- Trigger current: 2mA
- Switching Voltage: 240VAC@2A
- Triggering: Low-level
XH-M131 DC 12V Light Control Switch Photoresistor Relay Module
In Stock
SKU:008573- Material – Steel, Plastic, PVC
- Power Supply – DC 12V
- Operating Current – Before the relay actuation: less than 5mA Relay after pull-in: 5V module is less than 50mA
- Switching Voltage: 250VAC@10A; 30VDC@10A
5V 1 Channel Without Light Coupling Relay
In Stock
SKU:008570- The 8550 transistor drive, driveability.
- A fixed bolt holes for easy installation.
- It has a relay status indicator led Power LED(Green), 8 relay status indicator LED(Red)
- Relay control interface by single-chip IO.
- Low-level suction close, high-level release.
- Easy to use, simple 3 line structure.
Timing Delay Switch Circuit with Double MOSFET Control
In Stock
SKU:008565- Wide voltage power supply (6~30V)
- supports micro USB 5.0V power supply
- The interface is clear and simple, powerful, easy to understand
- All set parameters automatically save power.
ESP8266 ESP-01 5V WiFi Relay Module
In Stock
SKU:008560- Onboard Module: ESP8266 wifi module; in AP mode it can connect with 5 Clients at the same time
- Operating Way: cellphone carried on wifi module; cellphone and wifi module carried on the same router, and use the APP to control relay
- Transmission Distance : 400m (max)
- Relay : 5V,10A/250V AC 10A/30V DC
- Baud Rate: 9600.
- Diode effusion protection;
- Short response time
LR7843 Mosfet control Module Replacement Relay
In Stock
SKU:008555- Model: LR7843
- MOS tube: 30V 161A
- Dimensions: 30mm X 18mm
- Mounting Holes Diameter: 2mm
- Compatible with MCU and control board, 3V or 5V signal.
- High-level start, low-level stop, PWM speed regulation.
DC 12V Switch Delay-Relay Module with Adjustable Delay Time 0~25
In Stock
SKU:008548- Module based on: NE555 chip.
- Precision Pulse Generation / Timing.
- Adjustable Duty Cycle.
- Monostable Operation.
- Standby no power consumption
- Countless Application and Information Sources.
- Time can be adjusted by a potentiometer, the default is 0-25 seconds.
- Module supplies a diode with an anti-power reverse connection.
PC817 2 CH Optocoupler Isolation Module
In Stock
SKU:008542- I/O Isolation for MCUs (Micro Controller Units)
- Noise Suppression in Switching Circuits
- Driving Port Signal Voltage: 3.6-24V
- Output Port Voltage Port: 3.6-30V
- Output Can Be Switched From Pull-Up or Pull-Down With Jumpers.

We specialize in providing DIY electronics kits and components, empowering makers and hobbyists to build innovative projects. We also develop final year projects for engineering students, delivering hands-on solutions for academic excellence.
Contact Us
Customer Service
Store Information
© 2025 AtomlabIndia. All rights reserved.















